Wayne Dalton TorqueMaster vs Torsion Springs: Pros and Cons

Are Wayne Dalton TorqueMaster springs really a good choice, or should you switch to torsion springs? It’s a question homeowners and installers debate often. TorqueMaster springs have unique advantages - and a few drawbacks - that make them different from standard torsion springs.

In this guide (and video below), we’ll break down the pros and cons of the TorqueMaster system so you can decide if it’s the right fit for your garage door.

Pros of TorqueMaster Springs

• Safer enclosed design: The springs are housed inside a steel tube, reducing risk of injury if one breaks.
• Compact size: Great for low-ceiling garages where space is limited.
• DIY-friendly: Can be wound using a ratchet or even a drill - no need for torsion winding bars.
• Similar lifespan: Lasts about as long as torsion springs (7–10 years or ~10,000 cycles) when properly sized.
• Made in the USA: Built from the same steel quality as torsion springs, not cheap imported parts.

Cons of TorqueMaster Springs

• Hidden failures: Since the springs are enclosed, it can be harder to tell when they’ve broken.
• More moving parts: End assemblies have small gears and mechanisms that add complexity and potential failure points.
• Cost: Generally more expensive than torsion springs.
• Conversion expense: Switching from TorqueMaster to torsion requires new hardware and is costly.
• Improper sizing issues: If the wrong size spring is installed, over-winding can shorten its life to 2–5 years instead of 7–10.

Watch the Full Video

Are TorqueMaster Springs Right for You?

• If you want ease and safety for DIY replacement → TorqueMaster is a solid option.
• If you prefer a heavy-duty, simpler system with fewer moving parts → torsion springs are often better.
• If you already have TorqueMaster springs, replacing them like-for-like is usually the most cost-effective solution.

👉 Shop Wayne Dalton TorqueMaster Springs Here

FAQs About TorqueMaster vs. Torsion Springs

Q: Are TorqueMaster springs safer than torsion springs?
A: Yes. TorqueMaster springs are enclosed in a steel tube, so if they break, you’re shielded. Torsion springs are exposed and carry more visible tension.

Q: Do TorqueMaster springs last as long as torsion springs?
A: Yes. Both systems typically last 7–10 years or around 10,000 cycles when properly sized and installed.

Q: Why do some installers dislike TorqueMaster springs?
A: They’re more complex, have extra moving parts, and are harder to diagnose when broken. Many service pros prefer the simplicity of torsion systems.

Q: Can I convert from TorqueMaster to torsion springs?
A: Yes, but it requires a conversion kit, new hardware, and professional installation. It’s more costly than replacing TorqueMaster springs with the same system.

Q: Are TorqueMaster springs made from cheaper materials?
A: No. They’re made in the USA from the same steel as torsion springs. They’re simply thinner and enclosed in a different design.

Final Thoughts

Wayne Dalton TorqueMaster springs aren’t junk - they’re a homeowner-friendly, safe, and reliable option. While torsion springs are heavier-duty and simpler, TorqueMaster springs make replacement easier for DIYers and last about the same lifespan.

👉 Order Wayne Dalton TorqueMaster Springs from Express Garage Doors